除垢隊長 CLEAN CAPTAIN ｜官方網站｜洗衣槽清潔劑B劑 4000g 台灣製 洗衣槽清潔劑 B劑 4000g 台灣製 Washing Machine Tub Cleaner – Part B 4000g | Made in Taiwan

●產品名稱: B劑 除垢隊長 洗衣槽除垢新配方 專業清潔劑 B劑

●成份： 水、活氧除霉劑、碳酸鈉、去垢鹽、柑橘酵素、起泡劑

●容量：4000g ●酸鹼性：鹼性

●製造產地：台灣製造

●保存期限：5年

●工廠登記編號：66008416

●總經銷代理：好頭家創業股份有限公司

●產品特色: 活氧分解頑固黑垢、海苔垢、去除槽鋼壁吸附髒污、環保無毒深層清潔、不含氯無重金屬、無添加漂白水、無刺鼻味、淡淡橘香、去除洗衣槽內外看不見的病毒霉菌味、減緩長年霉菌垢附著衣物、造成皮膚紅癢過敏

●產品效用: 有效去除洗衣槽內外長期各式汙垢、髒汙、病菌、霉味，保養洗衣機洗槽增長洗衣機使用壽命。

●有效適用: 滾筒式、直立式洗衣機 ●洗衣容量：8～10公升，建議各劑350、500g 11～16公升，建議各劑500、1000g

●定期保養：依洗衣次數情況建議每月或半年保養一次

●使用方法: 《直立式洗衣機》:先將A劑全倒入洗衣槽並注滿水至高水位，溫度設定40度效果更好，按啟動鈕運轉讓本劑充分溶解，運轉同時注水至滿水位後拔掉電源插頭，靜置１日後分解出細菌汙垢，固狀汙垢可自行撈起，較大的苔垢或海帶垢，可使用小網子或容器先撈起來或用水管虹吸原理吸到水桶清除，再插入插頭開始脫水，脫水畢，接著在全倒入B劑注滿水位浸泡放置1日，重複上述清潔脫水步驟後，清除較大污垢後，添加洗衣精粉後在重新快洗或洗槽模式數次直到無污垢排出即可正常洗衣使用。 《滾筒式洗衣機》:因滾筒洗衣機多半無法滿水位，直接設定最高水位後，依直立式洗衣機操作方式即可。

●A劑、B劑分開靜置除垢效果更佳，如節省時間2劑一起倒入次佳。

使用後確實軟化洗衣槽鋼壁上苔垢、霉垢、髒汙等，但有可能洗衣槽鋼壁汙垢有成年較多，時間可再拉長或購買2組在拉長至各2日浸泡並可以的話在水溫設定高溫加快軟化，讓內部汙垢確實深層軟化後，藉由洗衣機馬達帶動，會使水流有引力從孔洞中將髒汙陸續帶出，此時可藉由水管利用紅吸原理在準備個水桶將裡滿髒汙吸出，因每台洗衣機使用年齡、情況不一樣，所以清潔劑排掉後，確實有需要讓洗衣槽在標準模式水洗數次來達到將髒汙不斷清除掉，在還未清除乾淨前，確實有可能還有些隨時會剝落的苔垢污垢因直接洗衣同時帶出，當水排乾後就會有汙垢附著衣物，這並非清潔劑本身問題，因為所有市面上清洗衣槽的清潔劑幾十元到數百元不等，除了效果差異不一樣外，確實需要洗衣槽標準洗清潔多幾次及耐心，軟化汙垢而達到不需請師傅施工拆卸就可能省去直立式1800～3500元的費用，畢竟長年洗衣槽汙垢當您發現洗不乾淨或容易衣物皮膚敏感時，通常都可能數年時間，使用後標準洗衣多清洗幾次是不可避免。

●注意事項:

1.本產品本身A劑有酸性特性，B劑有鹼性特性，請勿放置磁磚或大理石、花崗石、人造石檯面或接觸貴重金屬，避免液體殘留造成鈣化/氧化。

2.若不慎接觸到眼睛，請立即沖大量清水沖洗。

3.請置於小孩不易拿取之處。

4.滾筒洗衣機未滿水位時，一般而言最滿為1/3是正常現象，請勿額外注水。

5.AB兩劑同時注入後，會產生氣泡為中和反應現場為正常。

6.請勿與含有氯系清潔劑或漂白水或他牌清潔劑同時使用。

● Product Name: Agent B – "Clean Captain" (New Formula for Washing Machine Tub Descaling / Professional Cleaner)

● Ingredients: Water, active oxygen mold remover, sodium carbonate, descaling salts, citrus enzymes, foaming agent

● Capacity: 4000g

● pH Level: Alkaline

● Place of Manufacture: Taiwan

● Shelf Life: 5 years

● Factory Registration No.: 66008416

● General Distributor: Good Boss Venture ., Ltd.

● Product Features:

Uses active oxygen to break down stubborn black grime and algae-like deposits; removes dirt adhering to the tub walls; eco-friendly, non-toxic deep cleaning; free from chlorine, heavy metals, and added bleach; no pungent odor—leaves a mild citrus scent; eliminates invisible viruses, mold, and odors from both the inside and outside of the tub; helps prevent the buildup of long-term mold deposits that can transfer to clothes and cause skin irritation or allergic reactions.

● Product Benefits:

Effectively removes various types of long-term grime, dirt, germs, and moldy odors from the washing machine tub (interior and exterior); maintains the tub and extends the washing machine's service life. ● Suitable for: Front-loading and top-loading washing machines. ● Washing capacity: For 8–10L capacities, recommended amounts are 350g (Agent A) and 500g (Agent B); for 11–16L capacities, recommended amounts are 500g (Agent A) and 1000g (Agent B).

● Regular maintenance:

Depending on usage frequency, maintenance is recommended once a month or once every six months.

● Instructions: 《Top-loading washing machines》: Pour all of Agent A into the drum and fill with water to the maximum level (setting the temperature to 40°C enhances effectiveness). Press the start button to allow the agent to dissolve fully while filling to the maximum water level, then unplug the power cord. Let it sit for one day to break down bacteria and grime; skim off solid debris manually. Larger clumps of algae or seaweed-like residue can be removed using a small net or container, or siphoned into a bucket using a hose. Plug the machine back in and run the spin cycle. Once spinning is complete, pour in all of Agent B, fill with water, and let it soak for one day. Repeat the cleaning and spinning steps, remove any remaining large debris, add laundry detergent, and run a "Quick Wash" or "Tub Clean" cycle several times until no more dirt is discharged; the machine is then ready for normal use. 《Front-loading washing machines》: Since most front-loaders cannot fill to a "full" drum level, simply set the machine to its highest water level and follow the same operating procedure as for top-loading machines.

● Descaling is most effective when Agent A and Agent B are used separately with soaking intervals; however, pouring both agents in together is an acceptable alternative if you wish to save time. While the product effectively softens algae, mold, and grime on the washing machine drum's steel walls, stubborn, long-term buildup may require a longer soaking period—such as extending the process to two days per agent—or using two sets of the product. If possible, using high water temperatures can accelerate the softening process. Once the internal grime is thoroughly softened, the washing machine's motor generates water flow that draws the dirt out through the drum's perforations. You can then use a hose and the siphon principle to drain the dirty water into a separate bucket. Since every washing machine has a different age and usage history, it is essential to run several standard wash cycles after draining the cleaning solution to ensure all loosened grime is completely flushed out. Before the machine is fully clean, loose flakes of algae or grime might detach during a regular laundry cycle and adhere to your clothes; this is not a fault of the cleaner itself. Regardless of the price point of the cleaner (ranging from tens to hundreds of dollars), achieving results without professional disassembly—thereby saving the 1,800–3,500 TWD cost typically charged for servicing top-load washers—requires patience and multiple standard wash cycles to fully clear away years of accumulated grime.

● Precautions:

1. Agent A is acidic and Agent B is alkaline. Do not place them on surfaces made of tile, marble, granite, or engineered stone, and avoid contact with precious metals to prevent calcification or oxidation caused by liquid residue.

2. If the product comes into contact with your eyes, rinse immediately with plenty of water.

3. Keep out of reach of children.

4. For front-load washing machines, the water level typically reaches only one-third of the drum's capacity; this is normal, so do not add extra water.

5. Bubbles will form after adding both Agents A and B; this is a normal result of the neutralization reaction.

6. Do not use simultaneously with chlorine-based cleaners, bleach, or cleaners from other brands.